Lampat Dimmable Led Desk Lamp – Mounting the wall mount for your desk lamp can be confusing when you look at the individual components. However, the process is simple and requires no special tools.
Place the mounting bracket on the wall where you want the Lampat Dimmable Led Desk Lamp to hang. Lightly contour the bracket with your pen, marking position on the wall. Remove the bracket. Measure the location of the screw holes with your tape measure. If you have the keyhole-shaped screw holes in your bracket, measure to the narrow end. Use the tape measure and pen to mark the corresponding places on your wall. Drill a pilot hole in the wall at each screw whole location with a 1/8 inch drill.
Run a Lampat Dimmable Led Desk Lamp anchor in each pilot hole with your hammer. Screw a screw into each plaster wall anchor using the hand screwdriver. Leave 1/8 inch to 1/4 inch screw protruding from the wall. Delete the pencil marks from the wall. Fit the bracket to the screws. If your model has the screwdrivers exposed after mounting, and then tighten the screws by hand. If not, the base should be sufficiently thick to be stable.
Tips and warnings
These instructions assume that neither of your screws meets a wall rule. If one of your screws will drive into a stud, skip the drywall anchor step and use the drill to drive the screw directly into the stutter. Place the lamp at least 15 inches above the desk to avoid fire hazards and hit the head.