Drinking water faucet – Water conditioners help homeowners deal with hard water problems. When too much water containing dissolved calcium and magnesium can coat the body during a shower and these minerals from the soap stop correctly. Hard water also interferes with the cleaning detergent in the washing machine. Water conditioners remove these minerals, and some devices also capture iron.
Water conditioning must be attached to the main water line in the house if you want each drinking water faucet to produce softened water. Check your home for a pre-trough loop to connect the water conditioner. Disconnect the fuel or power source your water heater. Add media conditioning or salt pellets into the tank. Many units come pre-filled with these materials, so check the manual to determine if this step is necessary.
Screw the corresponding bypass valve in the drain on the device, then using a threaded connector to connect it to the tube. Screw or snap bypass control of the inlet valve. Turn both bypass valves to bypass or open position. Turn on the drinking water faucet at the main line and check for leaks at the inlet and outlet pipes. Plug the device in, and turn it according to the manufacturer’s instructions. Turn the water heater again when you are sure that the water conditioner is working properly and the tubes are refilled.